| Technical Specifications |
| Metering |
3 digit DPMs for voltage and current measurement. |
| Meter Accuracy |
±3 counts. |
Constant Voltage Mode |
|
| Regulation |
Line : ±0.01% ±2mV for ±10% change in line voltage.
Load : ±0.01% ±2mV for load change from zero to full load. |
| Ripple and Noise |
1mV rms max. 20Hz to 20MHz. |
Constant Current Mode |
|
| Regulation |
Line : ±0.05%
±10mA for ±10% change in line voltage.
Load : ±0.05% ±10mA for change in output voltage from 0 volts to maximum output voltage. |
| Ripple and Noise |
See Table. |
| Mode Indication |
LED indication for constant voltage / constant current operation mode. |
| Output Polarity |
Floating w.r.t. ground. |
| Overload Protection |
Constant current type. |
| Transient Response |
100µsec within 10mV of set output voltage for load change from 10% to 90%. |
| Stability |
Total drift within 8 hours, after 30 minutes warm-up under constant line, load and temperature.
< ±0.2% ±10mV in CV mode.
< ±0.5% ±10mA in current mode. |
| Operating Temperature |
0 to 50ºC. |
| Temp. Coefficient |
±0.05%
±5mV per ºC after initial warm-up of 30 minutes, in voltage mode. |
| Line Voltage |
230V AC ±10%, single phase 50Hz. |
| NOTE : REGULATION TO BE MEASURED AT SENSE TERMINALS. |
| CUSTOM CAPABILITY : SPECIAL VOLTAGE AND CURRENT RATINGS AVAILABLE ON REQUEST. |
